For each of the following, use the periodic table to determine the number of valence electrons in an atom of the element.
Ne S Mg Sn C Al Te Cs Bi Br Ga P

Answer:

We know that there are 6.022 * 10²³ atoms in 1 mole of any element

So, that means that there are 6.022 * 10²³ atoms in 1 mole of Li (Lithium)

Atoms in 3.7 Moles:

atoms in one mole = 6.022 * 10²³

atoms in 3.7 moles = 6.022 * 10²³ * 3.7

atoms in 3.7 moles = 22.28 * 10²³

atoms in 3.7 moles = 2.228 * 10²⁴

Answer:

Kindly check the attached picture.

Explanation:

Titration is one of the useful concept or practical in chemistry which is used in the determination of the concentration of a particular chemical specie. Without mincing words, let us dive straight into the solution to the question;

(a) Determining the equivalence point using the graph.

=> The equivalence point is the point at which there has been been "enough" addition of the acid to the base to give us the congugate acid. In the diagram showing the curve, it is the point labelled (a).

(b)The next thing is to determine the region with maximum buffering.

=> The position with the maximum buffering ranges from the point labelled (b) in the graph and it is the point when the acid and the base has been added. But the point with the maximum buffering is labeled as point (c).

(c). Determination of the point where pH = pKb.

=> The Point in which the pH = pKb is the point a

(d). The region where pH depends only on [B].

=> The starting point in the point in which the pH is dependent on the concentration of the base, [B].

(e). The region where pH depends only on [BH+].

=> This is the same point with point labelled as (a). Thus, point (a) and (e) are the same.

(f). The region where pH depends only on the amount of excess strong acid is the point labelled as (f) which is known as the post equivalence point.

Answer:

Phosphorus

Explanation:

Answer: The particles are moving fast but close together.

Answer:

its in the explanation.

Explanation:

1.In liquids, particles are quite close together and move with random motion throughout the container. Particles move rapidly in all directions but collide with each other more frequently than in gases due to shorter distances between particles.

2.It assumes the shape of the part of the container which it occupies particles can move/slide past one another.

Hope this helps. :)

Answer:

The orange-and-white clownfish you know from Hollywood is only one of 30 species of clownfish that live in coral reefs around the world; small in size and big in personality, these tiny comedians have one of the most unique lifestyles in the reef. The orange-and-white clownfish you know from Hollywood is only one of 30 species of clownfish that live in coral reefs around the world; small in size and big in personality, these tiny comedians have one of the most unique lifestyles in the reef.

Explanation:

point being, it would be absolutely terrible

Coral reef are the biggest biodiversity in the world. Therefore, destruction of coral reefs definitely affect the aquatic livings. As well as it leads to erosion of seashore lines.

Corals reefs are the habitat of 25% of sea organisms. It means there are well over a million species that rely on coral reefs for their existence. The reef offers these organisms the vital food, habitat, and breeding grounds required for the survival of their species.

The marine biodiversity would suffer greatly if their homes vanished. And many fish, turtles, and other species would vanish in a domino-like fashion.

Coral reefs are threatened by a number of things, such as local threats like overfishing, destructive fishing methods, coastal development, pollution, and careless tourism, as well as global effects of climate change like warming seas and rising CO₂ levels in the water. Natural phenomena like hurricanes, El Nio, and diseases are also a threat to oral reefs.

Find more on coral reefs:

https://brainly.com/question/364711

#SPJ6

Answer:

There are no options to this question, however, it can be answered. The answer is:

POSITIVE CORRELATION

Explanation:

Correlation refers to the relationship between two variables. It shows how related two variables are to one another. Hence, when two variables are correlated, there exists a relationship between them. Correlation can either be positive or negative depending on how related they are.

A positive correlation is that correlation in which the two variables are influenced to go in the same direction. That is, when one variable increases, the other variable increases as well and vice versa. This is the case in this question regarding the correlation between number of hours worked and take-home pay.

As the number of hours worked increases, the take-home pay also increases and vice versa. Hence, it is a type of POSITIVE CORRELATION

Answer:

Magnetic forces are non contact forces; they pull or push on objects without touching them. Magnets are only attracted to a few 'magnetic' metals and not all matter. Magnets are attracted to and repel other magnets.

Hope this helps!!!

Explanation:

Answer:

A. because salt : Na and Cl, not C

Answer:

He, Cl, As, C, Na

Explanation:

^^

Answer:

LA PRIMERA ES N

Explanation:

Answer:

Explanation:The ether functional group consists of an oxygen atom that forms single bonds with two carbon atoms

Answer:

0.75 moles of CO2

Explanation:

molar mass of CO2⇒ 44.01 g/mol

molar mass Oxygen ⇒ 31.998 g/mol

divide the mass given by molar mass of oxygen  so

48÷31.998= 1.50009376 moles of O

then you use the ration of oxygen to carbon to find the moles of CO2 which is one mole of CO2 for 2 moles of oxygen

1.50009376 moles of O ×[tex]\frac{1}{2}[/tex] = 0.75004688

with sig figs

0.75 moles of CO2

Answer:

mountain, mountain range, mountain system, mountain belt

Explanation:

edge 2021

Answer:

3.80 × 10²⁴ atoms of F

Explanation:

Step 1: Given data

Moles of barium fluoride (BaF₂): 3.16 mol

Step 2: Calculate the moles of fluorine in 3.16 moles of barium fluoride

The molar ratio of BaF₂ to F is 1:2. The moles of F in 3.16 moles of BaF₂ are 2/1 × 3.16 mol = 6.32 mol.

Step 3: Calculate the atoms of F in 6.32 moles of F

We will use Avogadro's number: there are 6.02 × 10²³ atoms of F in 1 mole of atoms of F.

6.32 mol × (6.02 × 10²³ atom/1 mol) = 3.80 × 10²⁴ atom

Answer:

0.75

Explanation:

3/4=0.75 so therefore its 0.75

Answer:

[a]. 55.5kmol/min.

[b]. The average velocity = 8.3m/s.

pipe diameter = 1.0954m.

Explanation:

So, from the question above we are given the following data or information or parameters which are going to help us in solving the above question;

=> ''A gas stream that contains 1.50 mole% CO2 flows through a pipeline''

=> ''Twenty (20.0) kilograms of CO2 per minute is injected into the line.''

=> '' . A sample of the gas is drawn from a point in the line 150 meters downstream of the injection point and found to contain 2.3 mole% CO2''

=> ''molar gas density is 0.123k mol/m3''

[a].The gas flow rate (k mol/min) upstream of the injection point can be calculated as follows.

- Determine the mass balance= j₁ +[ 20 /.123 × 44] = j₃. Thus, the flow gas rate is given as;

w₁ ×  1.50 mole% CO2 + 3.6954= 2.3 mole% CO2 × w₃.

-3.610 = - 0.008w₁.

w₁ = 451.3 m³/min.

Thus, the flow rate = 0.123 × 451.3 = 55.51 kmol/min.

[b]. The average velocity = 150/ 18 seconds = 8.3 m/s.

[c]. Pipe Diameter can be calculated as follows;

0.123  × 8.3  × [3.12  × (pipe diameter)² / 4] = 55.51/60.

[1.0209  × 3.12]/4  × [pipe diameter]² = 0.9252.

0.8014065  ×  [pipe diameter]² = 0.9252.

[pipe diameter]² = 0.9252/ .8014065.

[pipe diameter]² = 1.15443.

[pipe diameter] = √1.15443.

[pipe diameter] = 1.2 m² = 1.0954m.

A) The gas flow rate (k.mol/min) upstream of the injection point is;

55.51 k.mol/min

B) The average velocity and the diameter of the pipe are respectively;

8.33 m/s and 1.072 m

Due to the fact that there is no reaction or accumulation in the pipeline, we can say that the input of CO₂ is equal to it's output. Thus;

Upstream + Injection = Downstream

A) If we assume that x is the flow rate of gas (kmol/min), then there is the we can write the balance as:

0.015x + (20/44) = 0.023(x + 20/44)

Expanding gives us;

0.015x + 0.4545 = 0.023x + 0.01045

Solving for x gives;

x = 55.51 kmol/min

B) Formula for velocity is;

v = distance/time

Thus, since the length of the pipe is 150 m/s and time is 18 seconds, then velocity is;

v = 150/18

v = 8.33 m/s

Now, volumetric flow rate is calculated from;

Q = q' * ρ

where;

q' is gas flow rate

ρ is gas density

Thus;

Q = 55.51 * 0.123

Q = 451.3 m³/min = 7.522 m³/s

We can also express average velocity as;

v = Q/A

where A is area = πD²/4

Thus;

8.33 = 7.522/(πD²/4)

Making D the subject of the formula gives;

D = √((4 * 7.522)/(8.33π))

D = 1.072 m

Read more about Gas flow rate at; https://brainly.com/question/16014998

Answer:

The answer is

[tex] \huge 7.40 \times {10}^{21} Hz[/tex]

Explanation:

To find the frequency of the wave we use the formula

[tex]f = \frac{E}{h} \\ [/tex]

where

E is the energy

f is the frequency

h is the Planck's constant which is

6.626 × 10-³⁴ Js

From the question

E = 4.90 × 10-¹² J

So we have

[tex]f = \frac{4.90 \times {10}^{ - 12} }{6.626 \times {10}^{ - 34} } \\ [/tex]

We have the final answer as

[tex]7.40 \times {10}^{21} \: \: Hz[/tex]

Hope this helps you

Answer:

Longtitude

No explanation :)

Answer:

30 grams

Explanation:

density = mass / volume => mass = density x volume

mass = 0.856 g/cm³  x  35 cm³ = 29.96 grams ≅ 30 grams 2 sig. figs.  

Answer:

all of the above

Explanation:

The solubility of an ionic solid in a liquid solvent largely depends on three factors:

i) The solvation energy

ii) The lattice energy of the solid

iii) The polarity of the of the solvent

A large solvation energy and a small magnitude of lattice energy means that the ionic solute will dissolve very easily in the solvent.

Secondly, the solvent must have a large polarity, this is why water serves as a good solvent for most ionic solutes.

Answer: do not know how to answer this

Explanation:

Answer: In a closed system, only energy can be exchanged between the system and the surroundings. In the same example of boiling a pot of water, putting the lid on the system changes it from open to closed. This is because when the lid is on the pot, matter can no longer escape.

Explanation:

Answer:

I think its closed

Explanation:

Sorry if its wrong

Answer:

0.3+Na

Explanation:

Answer:

Explanation:

In my opinion the answer should be SO2

Answer:

a should be answer i think.

Answer:

2-pentene

hope this helps :)

Explanation:

Answer:

CO2 + H2O → O2 + C6H12O6

CO2 = carbon dioxide

H2O = water

O2 = oxygen

C6H12O6 = glukose

Answer:

Explanation:

Well a oceans waves could erode the beach it it is a rocky one, it can wash the sand out and can cause rocks to fall.